proimages/Otp Voice Ic/aP89 Family Easy Vioce/aP89010/Writer/aP89W24USB.jpg
Dimension: 12.4cm x 9.7cm x 4.2cm

P/N: aP89W24USB (PCB NO: 7181)
TO burn the DPM file into IC
Feature USB PORT
User Manual English version


proimages/Otp Voice Ic/aP89 Family Easy Vioce/aP89010/Demodoard/DB20P.PNG
Dimension: 3.6cm x 2.4 cm x 1.2 cm

        User Manual
English version

proimages/Otp Voice Ic/aP89 Family Easy Vioce/aP89010/Demodoard/DBTR20.PNG

        User Manual
English version


proimages/Otp Voice Ic/aP89 Family Easy Vioce/aP89010/copier/aP89C16-M2.jpg
Dimension: 18.3 cm x 12.2cm x 2.5cm

P/N: aP89C16-M2
       User Manual
English version


●Standard CMOS process.

●Embedded 256K bits EPROM.

●10Sec Voice Length at 6 KHz sampling and 4-bit ADPCM compression.

●Maximum 12 voice groups.

●Combination of voice building blocks to extend playback duration.

●960 table entries are available for voice block combinations.

●User selectable PCM or ADPCM data compress.

●Two triggering modes are available by whole chip option during voice compilation.

  ◆Key Trigger Mode          CPU Parallel Trigger Mode

●Voice Group Trigger Options: Edge/Level; Hold/Un-hold; Retrigger/Non-retrigger.

●Whole Chip Options: Ramp / No-ramp; Output Options; Key / CPU trigger mode.

●RST pin set to HIGH to stop playback at once.

●Three user programmable outputs for STOP plus, BUSY signal and flashing LED.

●Built-in oscillator to control sampling frequency with an external resistor.

●2.2V – 3.6V single power supply and < 5uA low stand-by current.

●PWM Vout1 and Vout2 drive speaker directly.

●D/A COUT to drive speaker through an external BJT.
●Development System support voice compilation and options selection.


    proimages/Otp Voice Ic/aP89 Family Easy Vioce/aP89010/ap89010_BLOCK_DIAGRAM.jpg

    proimages/Otp Voice Ic/aP89 Family Easy Vioce/aP89010/ap89010_typical_applications-1.jpg

    proimages/Otp Voice Ic/aP89 Family Easy Vioce/aP89010/ap89010_typical_applications-2.jpg


    proimages/Otp Voice Ic/aMTP777_11H/未命名.PNG 
      aP89010 high performance Voice OTP is fabricated with Standard CMOS process with embedded 256K bits EPROM.  It can
      store up to 10 sec voice message with 4-bit ADPCM compression at 6KHz sampling rate.8-bit PCM is also available as user  
      selectable option.Two trigger modes, simple Key trigger mode and Parallel CPU trigger mode facilitate different user interface.
      User selectable triggering and output signal options provide maximum flexibility to various applications.  Built-in resistor
      controlled oscillator, 8-bit current mode D/A output and PWM direct speaker driving output minimize the number of external 
      components.  PC controlled programmer and developing software are available.